Cutting a synergy si core

[stevoc 0]

I've heard that a synergy OPS can be cut to accept synergy blades. If I have a cracked blade on my si core grip, where about on the shaft do I want to cut to allow the use of a synergy blade?

I ask because I don't have any regular blade replacements on hand.

thanks

[devilsrule711 0]

try and use the search tool there are a bunch of synergy cutting threads search cutting synergies

[Nick23 0]

Just slowly cut up bit by bit until it fits, you might have to chisel some of the stuff inside out

[stevoc 0]

Thanks for the replies. I did some searching and here are a few links I found that discuss the process. Hopefully this will consolidate most of them.

http://www.modsquadhockey.com/index.php?showtopic=16729&hl=

http://www.modsquadhockey.com/index.php?showtopic=17311&hl=

http://www.modsquadhockey.com/index.php?showtopic=16007&hl=

http://www.modsquadhockey.com/index.php?showtopic=15887&hl=

http://www.modsquadhockey.com/index.php?sh...9313&hl=cutting

http://www.modsquadhockey.com/index.php?sh...pic=10997&st=15

http://www.modsquadhockey.com/index.php?showtopic=7494&hl=