OpenIceHit42 2 Report post Posted June 2, 2014 I’m making a table out of broken composite sticks and looking for some advice from anyone that’s made one. How did you piece the sticks together, with a small screw or did you use a glue of some sorts? Share this post Link to post Share on other sites
SirJW 207 Report post Posted June 2, 2014 Wood screws work. Share this post Link to post Share on other sites
Chadd 916 Report post Posted June 3, 2014 If you want it to hold up to use, screws would be a good idea. Epoxy may work, but I don't know that I would trust epoxy alone for anything that has to bear a significant amount of weight. Share this post Link to post Share on other sites
OpenIceHit42 2 Report post Posted June 3, 2014 Appreciate the input, wasn't sure if I run the risk of cracking the shaft if I ran a wood screw through it or not. Share this post Link to post Share on other sites
yrhmblnr8r 69 Report post Posted June 3, 2014 Appreciate the input, wasn't sure if I run the risk of cracking the shaft if I ran a wood screw through it or not. You shouldn't have to worry about cracking shafts if you drill pilot holes. Composite will wear down drill bits quickly, too. Buy a 5-pack of bits in the size you want and swap out once you feel you're forcing it. Share this post Link to post Share on other sites
theredmamba1 0 Report post Posted June 10, 2014 definitely wanna see a pic of the finished product! Share this post Link to post Share on other sites
